Kia Sorento: Blower

Auto Defogging Actuator Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the cowl side trim. (Refer to Body - "Crash Pad") ...

Blower Unit Components

1. Intake Case (LH) 2. Intake Case (RH) 3. Intake Door 4. Cowl Seal 5. NVH Seal 6. Blower Upper Case 7. Cluster Ionizer 8. Blower Lower Case 9. Power Mosfet (DAT ...

See also:

Front Strut Assembly Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Front Oil Seal Removal and Installation
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pullty") 2. Remove the front oil seal(A). ...

Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...