Kia Sorento: Blower Unit Components
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Unit Components
| 1. Intake Case (LH) 2. Intake Case (RH) 3. Intake Door 4. Cowl Seal 5. NVH Seal |
6. Blower Upper Case 7. Cluster Ionizer 8. Blower Lower Case 9. Power Mosfet (DATC) 10. Blower Resistor (Manual) |
11. Blower Motor 12. Air Cleaner Filter Cover 13. Air Cleaner Filter 14. Intake Actuator |
Blower
...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
See also:
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
Flat tire
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
(4) S ...
3. TCM Terminal input/ output signal
Connector [A]
Pin No.
Signal
Condition
Type
Level
29
Sports mode up switch
Up ON
Input
0V/Battery voltage level
...
Copyright В© www.ksmanual.com 2014-2024