Kia Sorento: Power Mosfet (DATC) Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Inspection
| 1. |
Measure the resistance between the terminals.
|
| 2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
Power Mosfet (DATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).
3.
...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Power Seat Motor Inspection
Power Seat Motor
1.
Disconnect the connectors for each motor.
(Refer to Body - "Front seat")
2.
With the b ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026