Kia Sorento: Power Mosfet (DATC) Replacement
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the passenger side crash pad under cover (A).
|
| 3. |
Disconnect the connector and then remove the power mosfet (A)
after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Power Mosfet (DATC) Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower
resistor must be rep ...
Climate Control Air Filter Description
The climate control air filter is located in the blower unit. It eliminates
foreign materials and odor. The particle filter performs a role as an odor filter
as well as a conventional dust fi ...
See also:
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Blind Spot Detection Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
...
Installation
•
Install the component with the specified torques.
•
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026