Kia Sorento: Blower Motor Replacement - Blower - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Blower Motor Replacement

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).

3.
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

4.
Install in the reverse order of removal.
Blower Motor Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

Blower Resistor Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

See also:

Specifications
ON/OFF Solenoid Valve(SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33 (5.0, 71.12) Internal resistance(Ω) ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

Evaporator Core Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Copyright В© www.ksmanual.com 2014-2023