Kia Sorento: Transfer Fluid Inspection - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Transfer Fluid Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Transfer Fluid Inspection

  
•
Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year.
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the oil filler plug (A).
[Gasoline 2.4]

[Gasoline 3.3]

3.
Check the oil level.
  
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the oil filler plug with new gasket.

Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

5.
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Transfer Assembly
...

Transfer Fluid Replacement
   Change Normal Use Severe Use No service required ...

See also:

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperatur ...

Front Fog Lamps Inspection
1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunctio ...

4WD ECU Description
4WD ECU processes signals from various sensors and determines the current road and driving conditions. The ECU then utilizes this information to implement precision control over the 4WD coupl ...

Copyright В© www.ksmanual.com 2014-2024