Severe driving conditions
* Transfer oil should be replaced if the transfer assembly is
fall into the water.
|
1. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
2. |
Drain the transfer oil after loosening the drain plug (A).
|
3. |
Install the drain plug with new gasket.
|
4. |
Remove the oil filler plug (A).
[Gasoline 2.4]
[Gasoline 3.3]
|
5. |
Add new oil through the filler plug hole.
|
6. |
Install the oil filler plug with new gasket.
|
7. |
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Engine Control Module (ECM) Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the ECM Connector (A).
...
Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose
of the air bag is to provide the vehicle's driver and/or the front passenger with
additional protection than that o ...