Kia Sorento: Rear Wiper Motor Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Inspection
Rear Wiper Motor
| 1. |
Remove the 4P connector from the rear wiper motor.
|
| 2. |
Connect battery positive (+) and negative (-) cables to terminals
3 and 4 respectively.
|
| 3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
1. IGN +
2. Parking
3. Switch
4. Ground
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the stalk control.
|
| 2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
| 3. |
Connect terminals 2 and 3.
|
| 4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
| 5. |
Check that the motor stops running at the off position.
|
Component Location
1. Rear wiper arm & blade
2. Tailgate glass hole
3. Grommet
4. Rear wiper arm nut
5. Rear wiper motor assembly
6. Head cap
7. Rear wiper motor bolt
...
Rear Wiper Motor Removal
1.
Detach the rear wiper cap (A).
2.
Remove the rear wiper arm & blade (A) after removing rear wiper
HEX nut (B).
...
See also:
Component Location
1. Slide motor
2. Front height motor
3. Rear height motor
4. Lumber support motor
5. Power seat switch
6. Reclining motor
7. Reclining switch
8. Lumber support swit ...
Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure
and DTC guide. ...
License Lamps Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens (A) from the panel after loosening
a screw.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026