Kia Sorento: Auto Defogging Sensor Inspection

To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.

Auto Defogging Sensor Description

The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module rece ...

Auto Defogging Sensor Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the auto defogging sensor cover (A). 3. Disconnect t ...

See also:

Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Water pump Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the dr ...