Kia Sorento: Rail Pressure Sensor (RPS)

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Installation

   • Install the component with the specified torques. • ...

Specification

...

See also:

Rear Wiper Motor Installation
1. Install the rear wiper motor assembly. Tightening torque Nut : 7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft) ...

Fuel Filler Door Open Switch Inspection
1. Remove the front door trim panel. (Refer to Body - "Front door") 2. Disconnect the switch connector (A) from wiring. ...

Ignition Coil Specification
Item Specification Primary Coil Resistance (Ω) 0.62 ± 10％ [20°C (68°F)] Secondary Coil Resistance (kΩ) 7.0 ± 15％ [20 ...