Kia Optima Manuals

Kia Sorento: Installation - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Rail Pressure Sensor Installation: 18.0 ~ 22.0 N.m (1.8 ~ 2.2 kgf.m, 13.3 ~ 16.2 lb-ft)
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refe ...

Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

See also:

Special Service Tools
Tool(Number and Name) Illustration Use 09581-11000 Piston expander Spreading the front disc brake piston. ...

Rear Door Components
1. Door inside handle cap 2. Door trim 3. Door belt inner weatherstrip 4. Door module 5. Door panel 6. Door belt weatherstrip 7. Door body side weatherstrip 8. Door ...

Roof Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof Trim Assembly") 2. Disconnect the power cable (A). ...

Categories

Copyright www.ksmanual.com 2014-2026