Kia Optima Manuals

Kia Sorento: Drive Plate Removal and Installation - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Drive Plate Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Removal and Installation

1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate (A) and the adapter plate (B).
Tightening torque :
117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft)

  
•
Always use new drive plate (or flywheel) bolts.
•
Apply sealant to the screw part (10mm from the end of the bolt) when reusing the drive plate bolts.
Sealant: Three bond 2403, Loctite 200 or 204
•
Install and uniformly tighten the 7 bolts, in several passes.
3.
Install in the reverse order of removal.
Components
1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

See also:

Rear Hub - Carrier Removal
1. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Starter Relay Inspection
1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). ...

Inspection (With GDS)
1. Check IPM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. ...

Categories

Copyright www.ksmanual.com 2014-2026