Kia Sorento: Front Wheel Transfer Assembly Installation - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Wheel Transfer Assembly Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Front Wheel Transfer Assembly Installation

1.
Install in the reverse order of removal.
  
1.
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2.
Smear and cover splines (B) with molybdenum type high pressure grease.

TECHLUBE MEGAMAX - ALPHA or equivalent

3.
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.

Front Wheel Transfer Assembly Removal
   It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is requ ...

Oil Seal Replacement
[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Re ...

See also:

Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid ...

Specifications
▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V) 12 Output type Pin to Pin ▷ Signal ...

Copyright www.ksmanual.com 2014-2026