It is not recommended to overhaul the transfer assembly because
a special three-dimensional measuring instrument is required to determine
the sizes of the transfer assembly spacers when disassembling and reassembling
the transfer assembly. If putting wrong sized spacers in the transfer
assembly, it may cause noise and vibration.So, if inner parts of the
transfer assembly need to be replaced, the transfer assembly should
be replaced with new one.
|
1. |
Remove the following items;
|
2. |
Remove the propeller shaft (A).
|
3. |
Loosen the transfer upper & lower mounting bolts. (transfer side
→ transaxle side)
|
4. |
Loosen the transfer lower mounting blot. (transaxle side → transfer
side)
|
Rear wheel alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to ...
AUX(Auxiliary) Jack Removal
Put on gloves to protect your hands.
...