Kia Sorento: Inhibitor Switch

Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals.

Installation

1. Install in the reverse order of removal.    • ...

Specifications

▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V) 12 Output type Pin to Pin ▷ Signal ...

See also:

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. ...

Parking Assist Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") ...

Fuel Tank Air Filter Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...