Kia Optima Manuals

Kia Sorento: Inspection - Inhibitor Switch - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch / Inspection

  
•
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Power Circuit Inspection
1.
Disconnect the Inhibitor swtich connector.
2.
Ignition KEY "ON"" & Engine "OFF".
3.
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Signal Circuit Inspection
1.
Connect the Inhibitor switch connector.
2.
Ignition KEY "ON" & Engine "OFF".
3.
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
Signal Code Table
　
 P
 P-R
 R
 R-N
 N
 N-D
 D
Signal "1"
 12V
 12V
 0
 0
 0
 0
 0
Signal "2"
 0
 12V
 12V
 12V
 0
 0
 0
Signal "3"
 0
 0
 0
 12V
 12V
 12V
 0
Signal "4"
 0
 0
 0
 0
 0
 12V
 12V

Circuit Diagram
...

Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

See also:

Component Location
[Engine Room] 1. Receiver-drier 2. Condenser 3. Ambient temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Assembly 7. Servic ...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Direct Electro Hydraulic Actuator Coupling Components
1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...

Categories

Copyright www.ksmanual.com 2014-2026