1. |
Disconnect the negative (-) battery terminal.
|
2. |
After loosening the mounting screws, then remove the tailgate
side trim (A).
(Refer to Body - "Tailgate")
|
3. |
Remove the anti-pinch strip sensor connector.
|
4. |
Remove the anti-pinch strip (A) after removing the clips (5EA).
|
Power Door Mirror Switch Inspection
1.
Remove the front door trim and power door mirror switch module
(A).
(Refer to Body - "Front door")
2.
Check fo ...
Rear Shock Absorber Removel
2WD
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 ...
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...