Never attempt to measure the circuit resistance of the Seat Belt
Pretensioner (BPT) even if you are using the specified tester. If the
circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench
(A).
Tight ...
Fuel Tank Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...