Kia Sorento: TJ Joint Inspection - Driveshaft Assembly - Driveshaft and axle - Kia Sorento XM 2011-2025 Service ManualKia Sorento: TJ Joint Inspection

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Inspection

1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
3.
Check the TJ boots for damage and deterioration.
TJ Joint Removal
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

See also:

Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 (or 3) fuse panels, one located in the driver’s side panel bolster, the other in the en ...

Rear combination lamp Installation
1. Install the tailgate combination lamp assembly after replacing the bulb. 2. Install the lamp cover to the tailgate after connecting the ...

Rear Wheel Speed Sensor Removal
4WD only 1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Copyright © www.ksmanual.com 2014-2025