1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the steering column upper and lower shrouds.
(Refer to Steering System - "Steering column")
|
3. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad")
|
4. |
Remove the ignition switch (A) after disconnecting the 6P connector
(A).
|
5. |
Remove the key warning and immobilizer connector (A).
|
6. |
Remove the key illumination lens (A).
|
7. |
Remove the key illumination bulb and cover (A).
|
8. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder with key ACC.
|
Head Lamps Inspection
1.
Check-points upon head lamp failure (HID)
(1)
Check the battery voltage. (Low beam will be on when the
battery voltage above 9V.) ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Auto Defogging Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
...