Kia Sorento: Installation - Variable Intake Solenoid (VIS) Valve - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve / Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine ...

See also:

Rear Glass Defogger Switch Installation
1. Install the heater control unit. 2. Install the center fascia panel. ...

Speakers Inspection
1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the s ...

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Copyright © www.ksmanual.com 2014-2023