Kia Sorento: Installation - Ignition Switch Assembly - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Ignition Switch Assembly / Installation

1.
Install the key lock cylinder.
2.
Install the illumination bulb, lens and cover.
3.
Install the key warning and immobilizer connector.
4.
Install the ignition switch.
5.
Install the steering column shrouds and crash pad lower panel.
Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to Steering System - &quo ...

Rear Parking Assist System
...

See also:

Rear Upper Arm Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Accelerator Pedal Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

Side Airbag (SAB) Module Removal
   The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. ...

Copyright В© www.ksmanual.com 2014-2023