Kia Sorento: Rear Oil Seal Removal - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Rear Oil Seal Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Removal

1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Rmove the rear oil sela(A).

Drive Plate Removal and Installation
1. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate ( ...

Rear Oil Seal Installation
1. Install rear oil seal. (1) Apply engine oil to a new oil seal lip. (2) Using SST(09 ...

See also:

Steering Column and Shaft Removal
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. ...

Copyright www.ksmanual.com 2014-2026