Kia Sorento: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Rear Oil Seal Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09231-H1100, 09214-2W200) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.

2.
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Install the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Ladder Frame Removal
   • Use fender covers to avoid damaging painted surfaces. • ...

See also:

Timing Chain Removal
1. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") 2. Turn the crankshaft pulley and ...

Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : Ins ...

Front Washer Motor Removal
   - When servicing the washer pump, be careful not to damage the washer pump seal. ...

Copyright www.ksmanual.com 2014-2026