Kia Sorento: Installation
| •
|
Do not reuse the used injector fixing clip.
|
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not reuse the used injector O-ring.
|
|
| •
|
Do not reuse the used bolt.
|
|
| •
|
When inserting the injector, be careful not to damage
the injector tip.
|
|
| •
|
Do not reuse the support disc.
|
| •
|
Do not reuse the injector rubber washer.
|
| •
|
When replacing the rubber washer, the steal plate (A)
part should be faced the cylinder installation part and the
rubber plate (B) part should be faced the injector body part.
|
|
| •
|
Do not reuse the combustion seal.
|
|
| •
|
When tightening the delivery pipe installation bolts,
tighten them in accordance with the order (
→  →  ) after
tightening with hand-screwed torque.
|
|
|
1. |
Install in the reverse order of removal.
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
See also:
Component Location (2)
1. Door outside handle button
2. Door outside handle
3. Bumper antenna
4. Tailgate switch
...
ATF Warmer Component
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch* fl ...
Removal
Replacement