Kia Sorento: Front Fog Lamps Inspection
| 1. |
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunction switch.
|
Rheostat Inspection
Front Fog Lamps RemovalKnock Sensor (KS)
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
Alternator Components
1. Overrun Alternator Pully (OAP)
2. Front bracket
3. Front bearing
4. Rotor
5. Rear bearing
6. Rear bracket
7. Through bolt
8. Regulator assembly
9. Regulator b ...
Interior D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front pillar ...