Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
|
| 3. |
Disconnect the injector connector (A).
|
| 4. |
Remove the installation bolt (B), and then remove the sensor from
the cylinder block.
|
Circuit Diagram
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD (Emergency Fastening Device)).
The pre-tensioner seat belts may be act ...
Console Components
[M/T]
1. Floor console assembly
2. Console upper cover
3. Console side cover [LH]
4. Console side cover [RH]
5. Rear console cover
6. Floor console mounting ...
Compressor Oil Specification
1.
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026