Kia Sorento: Idler Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Idler Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.

Remove the idler(A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Check the idler. if it is grease leak or abnormal rotation, replace the idler.

3.	Install in the reverse order of removal.

Drive Belt Inspection

1. Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt. ...

Drive Belt Tensioner Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt auto tensioner(A). ...

See also:

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to Steering System - &quo ...

Water pump Components
1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water pump housing 5. Water pump housing gasket 6. O-ring 7. Water inlet pipe ...

Categories

Copyright © www.ksmanual.com 2014-2026