Kia Sorento: Drive Belt Tensioner Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.

Remove the drive belt auto tensioner(A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Tensioner pulley bolt is left-hands screw.

3.

Remove the drive belt tensioner (A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

4.	Install in the reverse order of removal.

Idler Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightenin ...

Crankshaft Damper Pulley Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the passenger engine room side cover. (Ref ...

See also:

Battery Components
1. Battery insulation pad 2. Battery 3. Battery tray 4. Battery mounting bracket ...

Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased): Press and hold the left and center buttons simultaneously, until the indicator light begins to flash (approximately 20 ...

Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...

Categories

Copyright © www.ksmanual.com 2014-2026