Kia Sorento: Drive Belt Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Drive Belt Inspection

1.

Visually check the belt for excessive wear, frayed cords etc.

If any defect has been found, replace the drive belt.

Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Drive Belt Removal and Installation

1. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A). 2. Install the drive be ...

Idler Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightenin ...

See also:

Blind Spot Detection Switch Inspection
1. Disconnect the BSD switch connector. 2. Operate the BSD switch, then check for continuity between terminals of BSD switch connec ...

Accelerator Pedal Installation
1. Install in the reverse order of removal. Accelerator pedal module installation nut: 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18 ...

Components
1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. ABS Warning lamp 6. Parking brake/EBD warning lamp 7. ESC F ...

Categories

Copyright © www.ksmanual.com 2014-2026