1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
(Refer the Body - "Crash pad lower panel")
|
3. |
Remove the crash pad side switch assembly (A) after loosening
the screws.
|
4. |
Check the continuity between the switch terminals as the ESC OFF
switch is engaged.
|
Tire sidewall labeling
This information identifies and describes the fundamental characteristics of
the tire and also provides the tire identification number (TIN) for safety standard
certification. The TIN can be used ...
Specifications
Items
Wattage (W)
Type
Front
Standard
Head lamp (Low)
55
H7LL
HID
35
D3S
Head lamp (High)
5 ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...