Kia Optima Manuals

Kia Sorento: Crankshaft Damper Pulley Removal and Installation - Timing System - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Crankshaft Damper Pulley Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Removal and Installation

1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the passenger engine room side cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the passenger front tire.
4.
Remove the crankshaft damper pulley(A).
Tightening torque :
166.6 ~ 176.4 N.m (17.0 ~ 18.0 kgf.m, 122.9 ~ 130.1 lb-ft)

  
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.
•
Install the SST (09231-2B100) to hold the ring gear after removing the starter.
•
Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.
1.
Remove the dust cover (A) on the bottom of the ladder frame and unfasten the two transaxle mounting bolts (B).
2.
Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.
3.
Adjust the angle of the links (D) so that the two transaxle mounting bolts can be fastened to the original mounted holes.
4.
Install the SST (09231-3D100) using the two transaxle mounting bolts and spacers. Tighten the bolts and nuts of the holder and links securely.
5.
Install in the reverse order of removal.
Drive Belt Tensioner Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt auto tensioner(A). ...

Front Oil Seal Removal and Installation
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pullty") 2. Remove the front oil seal(A). ...

See also:

Occupant Detection System (ODS)
Your vehicle is equipped with an occupant detection system in the front passenger's seat. The occupant detection system is designed to detect the presence of a properly-seated front passenger ...

Seat warmer (if equipped)
The seat warmer is provided to warm the front seats during cold weather. With the ignition switch in the ON position, push either of the switches to warm the driver's seat or the front passeng ...

Rear Wiper Motor Installation
1. Install the rear wiper motor assembly. Tightening torque Nut : 7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft) ...

Categories

Copyright www.ksmanual.com 2014-2026