1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pullty")
|
2. |
Remove the front oil seal(A).
|
3. |
Install the crankshaft front oil seal (A) using SST (09214-2W100, 09231-H1100)
(B).
|
Timing Chain Cover Installation
1.
Install the timing chain cover.
(1)
Using a gasket scraper, remove all the old packing material
from the gasket surfaces.
...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
➀ BSD ...
ESC OFF Switch Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer the Body - & ...