Kia Sorento: Auto Defogging Sensor Description - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Auto Defogging Sensor Description

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Auto Defogging Sensor Description

The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Ambient Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper") ...

Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. ...

See also:

ICM Relay Box Description
The ICM relay is united with rear wiper relay, rear blower relay, rear seat warmer relay (LH/RH), two turn unlock relay and tailgate latch relay which installed inside the lower crash pad. ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm. Torque : 12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf. ...

Copyright В© www.ksmanual.com 2014-2024