Coupling Maintenance Precautions
Maintain the coupling at a horizontal level.
|
1. |
Remove the 4WD coupling assembly bolts (A-3ea) mounted to the
rear propeller shaft (B).
|
2. |
Using a flat tool, separate the propellar shaft from 4WD coupling
assembly.
|
3. |
Disconnect the pressure sensor connector (A) and Oil hydraulic
Motor connector (B).
|
4. |
Loosen the coupling assembly mounting bolts (A-4ea).
|
5. |
Using a flat tool, separate the 4WD coupling assembly from the
rear differential carrier assembly.
|
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Interior Trim Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Front door scuff trim
5. Rear door scuff trim
6. Cowlside trim
7. Rear pillar trim
8 ...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch* fl ...