Kia Sorento: A/C Pressure Transducer Description

The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system.

Receiver-Drier Replacement

1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tight ...

A/C Pressure Transducer Inspection

1. Measure the pressure of high pressure line by measuring voltage output between terminal “1� and “2�. 2. Inspect the volt ...

See also:

Under Body (2WD)
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

Rear Driveshaft Removal and Installation
1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Illuminated ignition switch (if equipped)
Whenever a front door is opened, the ignition switch will illuminate for your convenience, provided the ignition switch is not in the ON position. The light will go off immediately when the igniti ...