Kia Sorento: Reservoir Tank Removal and Installation - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Reservoir Tank Removal and Installation

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Mechanical System / Cooling System / Reservoir Tank Removal and Installation

1.
Remove the over flow hose(A).
2.
Remove the reservoir tank(B) after loosening the bolts.

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

3.
Install in the reverse order of removal.
Cooling Fan Disassembly
1. Remove the cooling fan (A) after loosening the screws (B) from the cooling assembly. Tightening torque: 2.7 ~ 3.2 N.m (0.28 ~ 0.3 ...

Water Temperature Control Assembly Components
1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant ho ...

See also:

Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel.    ...

Rear Door vReplacement
Door Trim Replacement    • When prying with a flat-tipped screwdriver, wrap it with p ...

General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Copyright В© www.ksmanual.com 2014-2024