Kia Sorento: Cooling Fan Disassembly - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Cooling Fan Disassembly

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Disassembly

1.
Remove the cooling fan (A) after loosening the screws (B) from the cooling assembly.

Tightening torque:
2.7 ~ 3.2 N.m (0.28 ~ 0.33 kgf.m, 2.0 ~ 2.3 lb-ft)

2.
Remove the fan motor (B) after loosening the screws (A) from the cooling fan shround.

Tightening torque:
3.9 ~ 5.8 N.m (0.4 ~ 0.6 kgf.m, 2.8 ~ 4.3 lb-ft)

3.
Install in the reverse order of removal.
Cooling Fan Removal and Installation
Cooling Fan Assembly 1. Disconnect the battery terminals. 2. Remove the air cleaner assembly. (Refer to Intake And Exhaust ...

Reservoir Tank Removal and Installation
1. Remove the over flow hose(A). 2. Remove the reservoir tank(B) after loosening the bolts. Tightening torque: ...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS)
Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Fuel Pressure Test (Low pressure system)
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

Copyright © www.ksmanual.com 2014-2019