Kia Sorento: Blower Motor Replacement

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the passenger side crash pad under cover (A).

3.	Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.

4.	Install in the reverse order of removal.

Blower Motor Inspection

1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

Blower Resistor Inspection

1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

See also:

Special Service Tools
Tool (Number and Name) Illustration Application RKE Battery Checker (09954-2P100) Measuring the RKE battery voltage Correction ...

Cylinder Head Cover Installation
1. Install cylinder head cover. (1) The hardened liquid gasket sealant located on the upper area between timing chain cover and cyli ...

In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

Categories

Copyright © www.ksmanual.com 2014-2025