Kia Sorento: Shift Cable Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Shift Cable Removal

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Removal

1.
Remove the floor console.
(Refer to Body - "Floor console")
2.
Remove the air duct.
3.
Disconnect the shift cable (A).

4.
Remove the retainer (A) and nut (B).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Remove the nut (C) from the manual control lever.

Tightening torque:
7.8~11.8 N.m (0.8~1.2 kgf.m, 5.8~8.7 lb-ft)

6.
Remove the cable (B) from the bracket (A) at transaxle assembly side.
7.
Remove the shift cable by pulling it toward the interior.

Shift Cable Components
1. Shift lever mounting bolt 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Cable Installation
1. Install in the reverse order of removal.    Set shift lever and inhibitor ...

See also:

Checking the washer fluid level
The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be use ...

Engine Cover Removal and Installation
1. Remove the engine cover (A). 2. Install in the reverse order of removal. ...

Brake Booster Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

Copyright © www.ksmanual.com 2014-2020