Kia Sorento: Blower Motor Inspection - Blower - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Blower Motor Inspection

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Inspection

1.
Connect the battery voltage and check the blower motor rotation.

2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
3.
Replace the blower motor if it is proved that there is a problem with it.
Blower Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. ...

Blower Motor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. ...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 screws. ...

Rear Driveshaft Removal and Installation
1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Copyright © www.ksmanual.com 2014-2019