Kia Optima Manuals

Kia Sorento: Front Bumper Replacement - Bumper - Body (Interior and Exterior) - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Bumper Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body (Interior and Exterior) / Bumper / Front Bumper Replacement

  
•
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
Loosen the radiator upper cover mounting bolts and clips.
2.
Loosen the front bumper lower mounting clips.
3.
After loosening the front bumper side's mounting screw, then disconnect the side's.
4.
Disconnect the fog lamp connector (A).
[LH]

[RH]
5.
Remove the front bumper cover (A).
6.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
Front Bumper Components
1. Front bumper cover 2. Front bumper lower stiffner 3. Front bumper upper stiffner 4. Front bumper side bracket ...

Rear Bumper Components
1. Rear bumper cover 2. Rear bumper lower bracket [RH] 3. Rear bumper lower bracket [LH] 4. Rear bumper side bracket [RH] 5. Rear bumper side bracket [LH] ...

See also:

Engine Control Module (ECM) Circuit Diagram
...

Specifications
▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V) 12 Output type Pin to Pin ▷ Signal ...

Front Strut Assembly Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Categories

Copyright www.ksmanual.com 2014-2026