Kia Sorento: Transaxle Oil Temperature Sensor Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Transaxle Oil Temperature Sensor Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Inspection

1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Disconnect the solenoid valve connector (A).

4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the resistance is within the specification.
Transaxle Oil Temperature Sensor Circuit Diagram
...

Transaxle Oil Temperature Sensor Removal
1. Remove the battery and the battery tray. (Refer to Engine Electrical System - "Battery") 2. Remove the under cover. ...

See also:

Specifications
Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 19.0 ~ 22.0 [20°C(68°F)] Fuel Tank Pre ...

Alternator Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

Radiator Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Ap ...

Copyright www.ksmanual.com 2014-2026