Kia Sorento: Emergency Fastening Device (EFD) Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the EFD cover pad (A).
|
| 3. |
Remove the seat belt after pushing the lock pin with a fiat-tip
screwdriver (B).
|
| 4. |
Remove the door scuff trim. (Refer to the Body group- Interior
trim)
|
| 5. |
Remove the center pillar trim. (Refer to the Body group- Interior
trim)
|
| 6. |
Disconnect the EFD connector (A).
|
| 7. |
Loosen the EFD mounting bolt (B) and remove the EFD.
|
Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on driver and pass ...
Emergency Fastening Device (EFD) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
See also:
Front Body E
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Hood hinge m ...
Oil hydraulic Motor(Actuator) Description
The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil
pressure. The pressure engages a multiple disk clutch to transfer torque to
the rear wheels. The torque to the rear wh ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts with the specified tightening
order.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026