Kia Sorento: Brake Line Removal - Brake System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Brake Line Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Brake System / Brake Line Removal

1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
  
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

5.
Remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~29.4 N.m (2.5 ~3.0 kgf.m, 18.1 ~21.7 lb-ft)

Front

Rear

Brake Line Components
...

Brake Line Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Filter replacement
It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Loosen the air clean ...

Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifo ...

Ladder Frame Installation
1. Apply liquid gasket to the mating surface of cylinder block and ladder frame.    ...

Copyright www.ksmanual.com 2014-2026