Kia Sorento: Starter Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Remove the ETC module.
(Refer to Fuel System - "ETC")
|
| 4. |
Remove the intake manifold stay (A).
|
| 5. |
Disconnect the starter cable (A) from the B terminal on the solenoid,
then disconnect the connector (B) from the S terminal.
|
| 6. |
Remove the 2 bolts (C) holding the starter, then remove the starter.
|
| 7. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly
may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearanc ...
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...
Temperature Control Actuator Replacement
[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's si ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026