Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (B).
|
| 5. |
Remove the installation bolts (C), and then remove the ETC module
from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Components
2WD
1. Rear upper arm
2. Rear stabilizer bar
3. Rear lower arm
4. Rear assist arm
5. Rear shock absorber
6. Rear cross member
7. Trailing arm
...
Circuit Diagram
...
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a bulb check.
The l ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026