Kia Sorento: Room Lamp Removal - Lighting System - Body Electrical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Room Lamp Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Lighting System / Room Lamp Removal

[General]
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver then replace the bulb.

3.
Loosen the fixing screw (2EA) and disconnect the 4P connector. And then remove the room lamp assembly (A).

[Sunroof]
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver then replace the bulb (B).

3.
If it is necessary to replace the lamp assembly, remove the room lamp (A).
  
Becareful not to damage the fixing clip (B) when disengaging the lamp assembly.

Room Lamp Inspection
1. Remove the room lamp assembly then check for continuity between terminals. [Sunroof] [General] ...

Room Lamp Installation
1. Install the room lamp assembly after connecting the lamp connector. 2. Install the lamp lens after assembling the bulb. ...

See also:

Crash Pad Components
1. Main crash pad assembly 2. Crash pad side cover [LH] 3. Crash pad side cover [RH] 4. Center fascia panel 5. Crash pad lower panel 6. Reinforce panel ...

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, ...

Copyright В© www.ksmanual.com 2014-2025