1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
2. |
Remove the battery (A) and check voltage if the red light doesn't
flicker.
|
3. |
Insert the battery (A) into the tester (09954-2P100).
|
4. |
Push the test button and If "0.00" is displayed on screen, it
means that the battery voltage is 2V or less.
|
5. |
If "L" is displayed on screen, it means that the battery is low
power and it needs to replace.
|
6. |
To prevent the discharge of electricity, turn the tester power
off.
|
7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
8. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors.
|
9. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, replace the transmitter.
|
IMS module Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat")
...
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Remove the surge tank. [G3.3 GDI]
(Refer to Engine Mechanical System - "Surge Tank")
...
Delivery Pipe Installation
•
Install the component with the specified torques.
...