Kia Sorento: Rear Washer Switch Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Rear Wiper Motor Installation

1. Install the rear wiper motor assembly. Tightening torque Nut : 7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft) ...

Rear Washer Motor Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...

See also:

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Coolant Refilling And Bleeding
   Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...

Alternator Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...